Burnham FM01FD00B Section I General Information, Table III Recommended Rear Service Clearance

SECTION I - GENERAL INFORMATION (Continued)

A.INSPECT SHIPMENT carefully for any signs of damage.

1.ALL EQUIPMENT is carefully manufactured, inspected and packed. Our responsibility ceases upon delivery of crated Boiler to the carrier in good condition.

2.ANY CLAIMS for damage or shortage in shipment must be filed immediately against the carrier by the consignee. No claims for variances from,

or shortage in orders, will be allowed by the manufacturer unless presented within thirty (30) days after the receipt of goods.

B.LOCATE THE UNIT

NOTICE

Recommended clearance for service may be reduced to minimum clearance to combustible material. However, increased service and maintenance difficulty will result.

1.RECOMMENDED SERVICE CLEARANCE

-Locate the unit in the boiler room so as to provide ease of venting and adequate clearance for maintenance, serviceability, and installation of piping. Refer to Figure 1b and Table 1 for boiler dimensional data.

from Jacket Front Panel:

•Provide 54” service clearance for removal, maintenance, and servicing of burner and controls.

•Provide service clearance for removal of baffles to perform annual cleaning of flueways, refer to Table I, Dimension “C”.

From Jacket Rear Panel:

•Provide a minimum service clearance from the boiler jacket for access to boiler supply and return piping, relief valve, drain valve, flue collector clean-out covers, vent piping and optional flue damper assembly. See

Table III.

Table III: Recommended Rear Service Clearance

Flue Outlet Size	Combustible or Non-Combustible
	Surfaces
7” Dia.	36
8” Dia.	36
10” Dia.	36
12” Dia.	36

From Jacket Left Side Panel:

•Provide clearance per Table I, Dimension ‘B’, for burner swing door (BSD), opened fully with burner mounted, otherwise 12” with burner removed.

•18” access clearance to service rear of boiler if right side clearance is less than 12”.

•12” minimum if right side clearance is 18” or larger to access and service rear of boiler.

From Jacket Right Side Panel:

•See Table I, Dimension ‘B’ if BSD is hinged to swing to right side with burner mounted, otherwise 12” minimum if left side clearance is 18” or larger to access and service rear of boiler.

From Jacket Top Panel:

•Provide a minimum clearance from the boiler jacket of 24”.

2.FOR MINIMUM CLEARANCES to combustible materials, See Table IV or Table V.

Table IV: Minimum Installation Clearances To

Combustible Materials (Inches) per

ANSI/NFPA 31 (Knockdown/Non-UL

Packaged Boiler)

			C
	A	B	Chimney	D	E
Boiler	Above	Front	Connector	Rear	Sides
MPC	6	24	18	6	6

Note: See Table III for recommended service clearance to access rear of boiler.

NOTE 1: Listed clearances comply with American National Standard ANSI/NFPA 31, Installation of Oil Burning Equipment.

NOTE 2: MPC Series boilers can be installed in rooms with clearances from combustible material as listed above. Listed clearances cannot be reduced for alcove or closet installations.

NOTE 3: For reduced clearances to combustible material, protection must be provided as described in the above ANSI/NFPA 31 Standard.

13