U.Install Optional Split Jacket Panels for Burner Swing Door (BSD) Cover (if applicable).
1.Open carton and remove contents.
2.Locate hanger bracket for BSD cover, secure to jacket front panel with three (3) #8 x 1/2” hex head SMS as shown in Figure 47.
3.Install left side BSD cover panel with offset bend as shown in Figure 47. Engage hooks on outer edge of panel through slotted openings on jacket front panel installed on boiler. At the same time, engage top flange of left cover panel behind hanger bracket, see
Figure 47, Detail ‘A’. Pull down on left cover panel to lock hooks in slots and top flange behind hanger bracket.
4.Install right side BSD cover panel using the same procedure used on left cover panel. Before locking panel in place, make sure right cover panel overlaps offset flange of left cover panel.
5.Secure panels together at seam using six (6) #8 x 1/2” lg. hex head SMS, one (1) screw on top and five (5) screws on the face as shown in Figure 47.
6.Locate Logo Plate shipped in Instruction Envelope. Peel paper off adhesive strips and install by inserting positioning tabs on rear of Logo Plate into slotted openings in upper left corner of left cover panel as shown in Figure 47.
Figure 47: Install Jacket Panels for Optional Burner Swing Door Cover
57
