Burnham FM01FD00B manual

3.Locate chaseway channel(s) shipped in Jacket Carton marked ‘JC-2’, see Figures 24c and 24d. Identify main chaseway channel by it’s unequal ends. Install the end with 8¼” lg. side flange under horizontal rail and through openings in junction box until end protrudes past rear horizontal channel. Secure main chaseway channel to both horizontal frame rails using #8 x 2½” lg. hex head sheet metal screws as shown in Figure 24c.

NOTE: Torque screws through rear frame rail until tight. At this time, only snug screws through forward rail(s) to allow movement in later assembly steps when attaching jacket top corner panels.

On 8 thru 18 sections block assemblies, install chaseway channel extension(s), see Figure 24d.

Position channel extension under next horizontal rail, secure bracket on extension to previously installed channel with two (2) #8 x ½” lg. hex head sheet metal screws. Torque these screws until tight. Secure front of channel extension to next horizontal rail with two (2) #8 x 2½” lg. sheet metal screws. Based on block size, repeat until chaseway extension has been secured to horizontal rail on front section.

4.Install protective edging to raw edges of chaseway channel(s) - Locate ‘JH-1’ Hardware Bag, packed in JC-1 Jacket Carton. From raw stock provided in Hardware Bag, cut two (2) pieces of protective edging 1-13/16” lg. and two (2) pieces 4-11/16” long.

Figure 24c: Internal Wiring Harness Components - Install Main Chaseway Channel

Figure 24d: Internal Wiring Harness Components - Install Chaseway Channel Extension(s)

39