OptipayCC

A-66 Coin Changer

S e c t i o n 8

8 CLEANING

This section explains how to clean the Optipay™ CC A-66 Coin Changer.

Only wipe the Coin Validator from time to time with a damp cloth (use luke warm water containing a mild dish cleaning liquid):

Under no circumstances allow the cloth to be wet enough to allow excess fluid to run into the device. Otherwise the printed circuit board (pcb) may be damaged.

Do not use any solvents or scouring agents which can attack the plastic surfaces of the device.

1.Remove the Vending Machine’s main AC power plug.

2.Press up on the locking catch lever and open the Coin Validator panel to the left

(See Figure 8-1 [1]).

3.Wipe the coin runway clean once inside the coin validation area.

4.Close the Coin Validator panel and gently press in on the "Close" arrow white dot until the metal spring engages behind the lever and a click is heard (See Figure 8-1 [2]).

5.Reconnect the Vending Machine to the main AC power supply.

Figure 8-1Opening and Closing the Coin Validator’s Access Panel

5900335 © 2005 JCM-American Corporation

8 - 1

Page 29
Image 29
C. Crane A-66 manual Cleaning, 1Opening and Closing the Coin Validator’s Access Panel