Cabletron Systems manual Installing AN Epim, Describes the ELS100-16TX buttons

Unpacking and Installing Your ELS100-16TX

Table 2-2 describes the ELS100-16TX buttons.

	Table 2-2. Description of ELS100-16TX Buttons
Button		Function
Status		Cycles through the Segment Status options (TX, RX,
		Act, Col, FDX, 100, MON, and Usr) for all ports. The
		right-hand port status LEDs of the ports you are
		monitoring are activated based on what function you
		chose with the Select button.
Reset		Restarts the ELS100-16TX.

2.2 INSTALLING AN EPIM

The ELS100-16TX provides two slots for a Cabletron EPIM-100FX (Ethernet Port Interface Module). The ELS100-16TX is shipped without EPIMs. To install an EPIM, follow the procedure below:

1.Remove the coverplate or the existing EPIM (whichever applies).

2.Slide the new EPIM into place, making sure that the connectors on the rear of the EPIM align correctly and firmly with the connector inside the ELS100-16TX.

Refer to Figure 2-2.

3.Install the mounting screw.

Caution: When removing an EPIM, pull the module straight out to prevent damage to the connector.

Note: The EPIM is hot swappable. Also, the RJ45 port corresponding to the EPIM port is disabled once an EPIM is installed.

2-4