SuperStack Application

This is a sequence of 16-bit numbers, each a pair of octets. Each encoded value represents a repeater. The value of the field Repeater Num may be set to any of the values in this list.

For example, is a port can be connected to repeaters 55, 92, and 333, the encoding would be:

Repeater 55

Repeater 92

Repeater 333

 

 

 

00.37

00.5c

01.4d

 

 

 

The final value would be 00.37.00.5c.01.4d.

Conn Type

Displays the connector type. Possible values are Unknown, RJ45, Telco, ST, SMA, Female-DType-15, BNC, SC, Male-DType-15, and Cascade.

SuperStack Application

This application suppports the SuperStack Configuration view. The model type name for this application is 3ComSSConfApp.

SuperStack Configuration View

This view provides the SuperStack Table. Double-click any field to access the Stack Config Entry view, in which you can modify the Name and Attention settings of a device.

Index

Displays a number used to identify individual devices in the stack. This value will usually be contiguous but gaps may be present due, for example, to unpowered devices.

Address

Displays the physical (MAC) address. Note that the index value can change if devices are inserted into the stack, but that the physical address will not.

Last Reset

Displays the time, in hundredths of a second, since this device was last reset. If a device is not operational, this will be zero.

Type

Displays a number that represents this type of device in the MIB.

The values of this integer are administered by allocating a MIB object identifier for each type of unit from a common branch. The value of this object is then the last level in that identifier. The values are defined in this MIB

Application Views

3Com PortSwitch Hubs

5-18

Management Module Guide

Page 63
Image 63
Cabletron Systems 3Com PortSwitch Hub manual SuperStack Application, SuperStack Configuration View, Conn Type, Last Reset