32
Explorer RIF Aging Time
On output, the Translational Switch UEM quickly deletes addresses known only from forwarded explorer frames. The session starts with an explorer frame followed by a specifically routed frame. The explorer frame’s RIF aging time makes it possible to limit the number of known address and RIF entries to established sessions. Possible values are 0 to 900 seconds. A RIF with an address is removed after this time if a specifically routed frame does not follow the explorer.
Default: 10 seconds
Frame Conversion Configuration
To configure frame conversion on a TS port, select Frame Conversion
Configuration on the Virtual Port Configuration menu of the TS port.
The following menu options are listed:
—IP Conversion Status
—IP conversion parameters change
IP Conversion Status
Display only. Shows the current status of the IP Conversion.
Possible values are Enabled and Disabled.
IP Conversion Parameters Change
To change IP conversion parameters select IP conversion parameters change on
the Frame Conversion Configuration menu of the TS port.
IP Frames Conversion
Sets the state of the IP frames Conversion. Possible values are Enabled and Disabled. If the state is set to Disabled IP, the traffic will be dropped.
Default: Enabled
IP: Token Ring Format
Sets the format of IP frames on Token Ring.
Format
Meaning
802.5 SNAP
Frame in the IEEE 802.5 format with SNAP
Table 7. IP: Token Ring Format
Configuration |
