Cadillac 2015 - CRC manual Learn or Smart Button

5-56 Instruments and Controls

hand-held transmitter was supplied by the manufacturer of the garage door opener receiver.

2. At the same time, press and
hold both the hand-held	.
transmitter button and one of the
three Universal Remote system
buttons to be used to operate
the garage door. Do not release
either button until the indicator
light changes from a slow to a
rapid flash. Then release both
buttons.
Some garage door openers may
require substitution of Step 2
with the procedure under in	.
“Radio Signals for Canada and
Some Gate Operators” later in
this section.

3.Press and hold the newly programmed Universal Remote system button for five seconds while watching the indicator light and garage door activation.

.If the indicator light stays on continuously or the garage door moves when the

button is pressed, then programming is complete. There is no need to complete Steps 4–6.

If the indicator light does not come on or the garage door does not move, a second button press may be required. For a second time, press and hold the newly programmed button for five seconds. If the light stays on or the garage door moves, programming is complete.

If the indicator light blinks rapidly for two seconds, then changes to a solid light and the garage door does not move, continue with programming Steps 4–6.

Learn or Smart Button

4.After completing Steps 1–3, locate the Learn or Smart button inside the garage on the garage door opener receiver. The name and color of the button may vary by manufacturer.

5.Press and release the Learn or Smart button. Step 6 must be completed within 30 seconds of pressing this button.

6.Inside the vehicle, press and hold the newly programmed Universal Remote system button for two seconds and then release it. If the garage door does not move or the lamp on the garage door opener receiver