In Brief

1-5

Remote Vehicle Start

If equipped with remote start, the engine can be started from outside of the vehicle.

Starting the Vehicle

1.Press and release Q on the RKE transmitter.

2.Immediately press and hold / for at least four seconds or until the turn signal lamps flash.

3.Press the brake pedal and select the ON/RUN/START ignition mode to drive the vehicle.

When the vehicle starts, the parking lamps will turn on and remain on as long as the engine is running. The doors will be locked and the climate control system may come on.

The engine will continue to run for 10 minutes. After 30 seconds, repeat the steps if a 10-minute extension is desired. Remote start can be extended only once.

Canceling a Remote Start

To cancel a remote start, do any of the following:

.Press and hold / until the parking lamps turn off.

.Turn on the hazard warning flashers.

.Turn the vehicle on and then off.

See Remote Vehicle Start on page 2-9.

Door Locks

To lock or unlock a door manually:

.Use the key in the driver door. The key cylinder is covered by a cap. See Door Locks on

page 2-11.

.From the inside, to lock a door push down on the door lock knob on top of the door. To unlock a door, pull once on the door handle to unlock it, and again to open it.

Power Door Locks

. From the inside, press Q or K. See Power Door Locks on page 2-13.

.From the outside, press Q or K on the RKE transmitter. See

Remote Keyless Entry (RKE) System Operation on page 2-2.

From the outside, if the vehicle is equipped with Keyless Access, press the button on the door handle when the Remote Keyless Entry (RKE) transmitter is within range to

Page 12
Image 12
Cadillac 2015 - CRC manual Remote Vehicle Start, Starting the Vehicle, Canceling a Remote Start, Power Door Locks