9-18 Driving and Operating

Driver Information Center (DIC) will display a message. See Key and Lock Messages on

page 5-39.

{Caution

Cranking the engine for long periods of time, by pressing the ENGINE START/STOP button immediately after cranking has ended, can overheat and damage the cranking motor, and drain the battery. Wait at least 15 seconds between each try, to let the cranking motor cool down.

2.If the engine does not start after five to 10 seconds, especially in very cold weather (below 18°C or 0°F), it could be flooded with too much gasoline. Try pushing the accelerator pedal all the way to the floor and holding it there as you press the ENGINE START/STOP button, for up to a maximum of 15 seconds. Wait at least 15 seconds between each

try, to allow the cranking motor to cool down. When the engine starts, let go of the button and the accelerator. If the vehicle starts briefly but then stops again, do the same thing. This clears the extra gasoline from the engine. Do not race the engine immediately after starting it. Operate the engine and transmission gently until the oil warms up and lubricates all moving parts.

Engine Heater

The engine coolant heater,

if available, can help in cold weather conditions at or below 18°C (0°F) for easier starting and better fuel economy during engine warm-up. Plug in the coolant heater at least four hours before starting the vehicle. An internal thermostat in the plug end of the cord will prevent engine coolant heater operation at temperatures above 18°C (0°F).

To Use the Engine Coolant Heater

1.Turn off the engine.

2.Open the hood and unwrap the electrical cord.

The electrical cord is on the driver side of the engine compartment, between the fender and the engine compartment fuse block.

Page 217
Image 217
Cadillac 2015 - CRC manual Engine Heater, To Use the Engine Coolant Heater