Setting
Power management
For reducing power consumption as well as maintaining the lamp life, the Power management function turns off the projection lamp when the input signal is interrupted and no button is pressed for a certain period.
If the input signal is interrupted and no button is pressed for 30 seconds or more, the timer display with the message "No signal" appears on the screen. The
When the
Ready . . . . . .When the lamp has been fully cooled down, the POWER indicator changes to green blinking. In this condition, the projection lamp will be turned on if the input signal is reconnected or any button on the top control or remote control unit is pressed.
Shutdown . . .When the lamp has been fully cooled down, the power will be turned off.
Off . . . . . . . . .The Power management function is canceled.
On start
When this function is “On”, the projector is automatically turned on just by connecting the AC power cord to a wall outlet.
Press the Point 78 button to switch On / Off.
✔Note:
•Be sure to turn the projector off properly (see “Turning Off the Projector” on page 18). If the projector is turned off in the incorrect sequence, such as disconnecting the AC power cord before completing the cool down etc., the On start function does not operate properly.
Lamp mode
This function allows you to change the brightness of the screen.
Normal | .........normal brightness |
Auto | brightness according with the input signal |
Silent | lower brightness reduces the lamp power |
| consumption and extends the lamp life. |
| The sound is quiet. |
Power management
Time left until Lamp off
Press the OK button at Power management and this box appears. Select one of three settings with the Point 7 8 buttons, and go to the timer with the Point ed buttons and set time with the Point 7
8buttons.
Setting
41
