Cause

Action

Document jams in the ADF (Document

(5)Close the Feeder Cover.

Tray).

z If documents remain in the ADF after pressing the Stop/Reset button during

(Continued)

scanning, “DOCUMENT IN ADF” appears on the LCD. Press the OK button

 

so that the remaining document is automatically fed out.

 

z When rescanning the document after clearing the error, rescan it from the

 

first page.

 

If you cannot remove the document or the document tears inside the machine,

 

or if the document jam error continues after removing the document, contact

 

your Canon service representative.

Note

The document may not feed properly depending on the media type, or your environment, such as when the temperature and humidity are either too high or too low.

In this case, reduce the number of document pages to approximately half of the loading capacity. See “Original Document Requirements” on page 8.

If the document still jams, use the Platen Glass instead.

Document jams in the ADF (inner side). Remove the document following the procedure below.

(1)Follow steps (1) to (3) under “Document jams in the ADF (Document Tray).” on page 91.

(2)Open the Document Cover and pull out the document from the inner side.

(3)Close the Document Cover.

(4)Close the Feeder Cover.

zWhen rescanning the document after clearing the error, rescan it from the first page.

If you cannot remove the document or the document tears inside the machine, or if the document jam error continues after removing the document, contact your Canon service representative.

92Troubleshooting