Carrier
Viewing the Electric Heat Jumper Setting
Placing the jumper on ELEC will cause the thermostat to turn on the fan immediately any time there is a heat demand. Since most gas furnaces control the fan, this feature should be off unless it is necessary for the thermostat to energize the fan with first stage heat.
Step 21 is ‘Read Only’ and may only be set with the jumpers on the circuit board of the thermostat.
MODE | Press the MODE button. While holding | |
| the MODE, press the PROGRAM | |
PROGRAM | button to enter Setup screens. | |
MODE | Press the MODE button repeatedly | |
until this setup screen appears. | ||
|
Note: Press the MODE button momentarily to move through the setup screens. Press and hold the MODE button to move back- wards through the setup screens.
12
ON indicates that the thermostat jumper is set for Electric Heat operation, or OFF for Gas/Electric or Heat Pump operation.
OFF
EHSetup 2 i
Press
PROGRAM
Press the PROGRAM button to leave the Setup screens. If no buttons are pressed, the display will leave the setup screens after 30 seconds.
Page 12.3
