Carrier
Averaging the Remote Sensor (RS1) with the Thermostat Sensor
If step #37 is set to control to the remote sensor, the thermostat will ignore the reading of its internal temperature sensor and only display the temperature reading from the remote sensor. The degree icon on the thermostat will blink once per second to indicate that a remote sensor reading is being displayed.
If step #38 is set to ON (see below), the thermostat will average its internal sensor with the wired temperature sensor connected to RS1. If multiple remote temperature sensors are installed on RS1, they will automatically average together. The temperature displayed will be the average of the thermostat’s internal sensor and the remote (RS1) sensor(s).
MODE
PROGRAM
MODE
Press the MODE button. While holding the MODE, press the PROGRAM button to enter Setup screens.
Press the MODE button repeatedly until this setup screen appears.
Note: Press the MODE button momentarily to move through the setup screens. Press and hold the MODE button to move back- wards through the setup screens.
15
Optional Remote Sensor
On
Operation:
ON = Averages thermostat sensor with Remote Sensor 1.
OFF = Does not average thermostat sensor
Off
with Remote Sensor 1.
OFF
Setup38
Remote
Press
PROGRAM
Press the PROGRAM button to leave the Setup screens. If no buttons are pressed, the display will leave the setup screens after 30 seconds.
Page 15.4
