Carrier 33CS450-01 owner manual Internet/Phone Control of the Programmable Output, Page, Carrier

Carrier

Internet/Phone Control of the

Programmable Output

To operate a MISC output using Internet/phone-based operation, program advanced setup step #30 for Aux (below). This terminal is especially useful for devices that can be energized via the Internet. Telephone control may also be available when the thermostat is connected to the Internet.

Possible REMOTE scenarios:

1)Arm the alarm system in your building after you have left for the day.

2)Turn off your sign lights after arriving home.

3)Turn on your interior lights while you’re closed.

MODE	Press the MODE button. While holding				Note: Press the MODE
	the MODE, press the PROGRAM				button	momentarily
PROGRAM	button to enter Setup screens.				to move through the
					setup screens. Press
					and hold the MODE
	Press the MODE button repeatedly				button to move back-
MODE					wards	through the
	until this setup screen appears.				setup screens.
							14
OFF	Time = I8:88 Temp = 88	Aux
			Setup		30
Press the UP button three
times to set the
programmable output
for Aux (web-based				AUX
operation).						Press
						MODE
NC Programmable Output Polarity:			Setup		3 i
NC = Normally Closed to operate
when programmed to be OFF
through the phone or internet.
NO = Normally Open to operate						Press
when programmed to be ON
NO through the phone or internet.						PROGRAM

Press the PROGRAM button to leave the Setup screens. If no buttons are pressed, the display will leave the setup screens after 30 seconds.

Page 14.7