Carrier 33CS450-01 Programmable Output, Temperature-Based Control of the, Page, Carrier, Time =

Carrier

Temperature-Based Control of the

Programmable Output

To operate a MISC output using temperature-based operation, program advanced setup step #30 (below) for temperature 88 . This extra output will supply 24VAC to the selected MISC terminal based on the temperature of RS1 and the setpoint in step #36 (below).

Possible TEMPERATURE scenario:

1)An exhaust fan in the attic of a store that needs to be energ- ized when the attic temperature is above 85 degrees.

MODE

PROGRAM

MODE

Press the MODE button. While holding the MODE, press the PROGRAM button to enter Setup screens.

Press the MODE button repeatedly until this setup screen appears.

Note: Press the MODE button momentarily to move through the setup screens. Press and hold the MODE button to move back- wards through the setup screens.

OFF		Time = I8:88	Temp = 88	Aux
				Setup	30
		Press the UP button twice		88Setup
		to set the programmable
14		output for temperature-
		based operation. The
		large temperature digits
		will appear.
NC	Programmable Output Polarity:				3 i
	NC = Normally Closed to operate
		when the setpoint is less than
		the setpoint in step #36.
	NO = Normally Open to operate
		when the setpoint is equal to or
NO		greater than the setpoint in step
		#36.

80Setup 36

Adjust the programmable output setpoint.

o o

(35-125 )

Press

MODE

Press

MODE

Press

PROGRAM

Press the PROGRAM button to leave the Setup screens. If no buttons are pressed, the display will leave the setup screens after 30 seconds.

Page 14.6