Carrier 33CS450-01 Adjusting the Humidification Setpoint, Page, Carrier, Press the HUMIDITY

Carrier

Adjusting the Humidification Setpoint

If your HVAC unit is equipped with a humidification system and the Humidity Module has been installed, the thermostat will provide power to the appropriate terminal on the backplate of the thermostat when the humidity in the building falls below the setpoint you have chosen. The value for this setpoint ranges from 0% to 60%.

NOTE: Due to variations in environmental conditions, it is not always possible to achieve the desired humidification or dehumidification setpoint.

HUMIDITY	Press the HUMIDITY	NOTE: Each step # is located at
	button to enter the	the top right corner of the
	Humidity Setup screen.	display for easy reference.
			9

		40		I
	Current Room Humidity		0
			Setup
Adjust the desired			Humidify
humidification setpoint
(0%-60%)					Press
					HUMIDITY

Press the HUMIDITY button to leave the Humidity Control screens (if no buttons are pressed, the display will leave the Humidity Control screens after 30 seconds).

Humidification Notes: Press the button to set the humidity setpoint to 0% for no humidification operation.

You cannot set the dehumidify setpoint any lower than the humidify setpoint; a 5% differential is forced between the humidify and dehumidify setpoints.

Page 9.4