START-UP CHECKLIST
(Remove and Store in Job File)
I. PRELIMINARY INFORMATION
MODEL NO.: __________________________________ | SERIAL NO.: ______________________________________ |
DATE: ________________________________________ | TECHNICIAN: _____________________________________ |
BUILDING LOCATION: _________________________ |
|
II.
VERIFY THAT CONDENSATE CONNECTION IS INSTALLED PER INSTALLATION INSTRUCTIONS
CHECK ALL ELECTRICAL CONNECTIONS AND TERMINALS FOR TIGHTNESS
CHECK THAT RETURN (INDOOR) AIR FILTERS ARE CLEAN AND IN PLACE
VERIFY THAT UNIT INSTALLATION IS LEVEL
CHECK FAN WHEEL AND PROPELLER FOR LOCATION IN HOUSING/ORIFICE AND SETSCREW TIGHTNESS
CHECK PULLEY ALIGNMENT AND BELT TENSION PER INSTALLATION INSTRUCTIONS
VERIFY INSTALLATION OF ECONOMIZER HOOD (IF EQUIPPED)
III.START-UP:
ELECTRICAL
SUPPLY VOLTAGE |
|
| |||
CIRCUIT 1 COMPRESSOR AMPS L1 |
| L2 |
| L3 | |
CIRCUIT 2 COMPRESSOR AMPS L1 |
| L2 |
| L3 | |
L1 |
| L2 |
| L3 |
TEMPERATURES |
|
|
|
|
| DB |
| WB | |
| DB |
| WB | |
COOLING SUPPLY AIR |
| DB |
| WB |
PRESSURES (COOLING MODE) |
|
|
|
|
REFRIGERANT SUCTION, CIRCUIT 1 |
| PSIG |
| F |
REFRIGERANT SUCTION, CIRCUIT 2 |
| PSIG |
| F |
REFRIGERANT DISCHARGE, CIRCUIT 1 |
| PSIG |
| F |
REFRIGERANT DISCHARGE, CIRCUIT 2 |
| PSIG |
| F |
VERIFY THAT
GENERAL
SET ECONOMIZER MINIMUM VENT AND CHANGEOVER SETTINGS TO MATCH JOB REQUIREMENTS (IF EQUIPPED)
Copyright 2005 Carrier Corporation
Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations.
Book | 1 | 4 | Catalog No. | Printed in U.S.A. | Form | Pg | Replaces: | |
Tab | 5a | 5a |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -