1.10ENGINE DATA (Continued)
| Oil Pressure Safety |
| 18 psig (1.27 kg/cm2) |
| |||
| Switch Setting |
|
| ||||
| Opens |
|
|
|
|
| |
| Capacity | Engine | |||||
|
|
|
|
| |||
|
| Dipstick in oil pan or fill cap | |||||
|
|
|
| NOTE |
| ||
|
| To check oil level on engines with the dipstick mounted in the | |||||
| Oil Level Indicator | fill cap, remove the cap and wipe the dipstick clean. Insert the | |||||
| cap back onto the oil fill tube, then remove to check level. It is | ||||||
f. Lubrication System |
| not necessary to screw the cap back into the fill tube when | |||||
| checking level. DO NOT add oil if level is within the “safe” | ||||||
|
| range. If needed, add oil to bring level within the “safe” range. | |||||
|
| Screw cap fully into fill tube after checking level. | |||||
| Lube Oil | Use a heavy duty lubricating oil conforming to American Pe- | |||||
| troleum Institute (API) Service Classification CG, CH or CI, | ||||||
| Specification | ||||||
| Base Number 10 or above. |
| |||||
|
|
| |||||
|
|
|
|
|
|
| |
|
|
| Outdoor Temperature |
| |||
|
|
|
| Centigrade |
|
| |
| Lube Oil Viscosity | Fahrenheit |
|
| SAE | ||
|
|
|
|
|
| ||
| 0F to 45F |
|
| 10W30 | |||
|
|
|
| ||||
|
|
|
| 7C and above |
|
| |
|
| 45F and above |
|
| 10W30 or 15W40 | ||
|
|
|
|
|
| ||
| Winter |
| Summer | ||||
|
|
|
| ||||
g. Fuel and Fuel Heater | Diesel No. 1 |
| Diesel No. 2 | ||||
|
|
|
|
|
| ||
| FHT |
| |||||
Thermostat (FHT) |
|
| |||||
|
|
|
|
|
| ||
| Close on temperature fall @ |
| Open on temperature rise @ | ||||
|
|
| |||||
| Power Consumption: 150 Watts @ | ||||||
|
|
|
| ||||
h. Intake Heater Amperage |
| 42 amps at 12 VDC |
| ||||
i. Horsepower | 27 HP @ 1800 RPM at 3000 feet above sea level. | ||||||
|
|
|
|
|
| ||
| 32 HP @ 1800 RPM at sea level. |
| |||||
|
|
| |||||
|
|
| |||||
| Capacity | 6 U.S. quarts (5.68 liters) | |||||
| coolant recovery bottle. (Refer to section 4.4.5) | ||||||
|
| ||||||
|
|
| |||||
|
| The cooling system may be factory charged with a 50/50 mix | |||||
| of ethylene glycol and water. This mixture provides protection | ||||||
| to | ||||||
| Conventional | ||||||
| freeze meeting GM specifications GM 6038M or equal. Again, | ||||||
|
| ||||||
|
| a 50/50 mix is recommended. |
| ||||
|
|
| |||||
|
| The cooling system may be factory charged with a 50/50 mix | |||||
|
| of extended life coolant (ELC) and deionized water. This mix- | |||||
| ture provides protection to | ||||||
| with extended life coolant (ELC) meeting GM specification | ||||||
j. Cooling System | Extended Life | ||||||
GM6277M and deionized water. Again, a 50/50 mix is recom- | |||||||
|
| mended. Extended life coolant is red or orange in color. | |||||
|
| DO NOT mix with conventional coolant. |
| ||||
|
|
|
|
| |||
| Water Temperature | Opens |
| 230 | |||
| Safety Switch |
|
|
|
|
| |
| Resets |
| 200F (93C) | ||||
| Setting |
| |||||
|
|
|
|
| |||
| Thermostat | Starts to open |
| 177 to 182F (80 to 84C) | |||
|
|
|
|
|
| ||
| Fully open |
| 203F (95C) | ||||
|
|
| |||||
|
|
|
|
| |||
| Low Coolant | Opens |
| Loss of 32 ounces of coolant or more | |||
| Sensor | Closes |
| Refilling of radiator to proper level | |||
|
|
|
| ||||
k. Lubrication System | Oil Pressure | 35 to | 60 psig (3.3 to 5.2 kg/cm@) |
|