Casio ACS V6000 ACS v6000 Installation/Administration/User Guide, Ctrl-X, ParameterDescription

30 ACS v6000 Installation/Administration/User Guide

ParameterDescription

Enable Auto Discovery

The target name will be discovered and will be associated with this serial port. If it fails, the Port Name will be used. Default: Disabled.

Protocol

The protocol that will be used to access the serial port/target. SSH - Authorized users can use SSH to connect to the console of a connected device. Telnet - Authorized users can use Telnet to connect to the console of a connected device. SSH/Telnet - Authorized users can use SSH and/or Telnet to connect to the console of a connected device simultaneously. Raw - Authorized users can make a Raw Socket connection to the console of a connected device. Default: SSH/Telnet.

Authentication Type

Authentication type that will be used to authenticate the user during target session. Default: Local.

Hotkey to suspend the target session and go to the CLI prompt. Not Text Session Hot Key available for Raw. Default: Ctrl-Z. NOTE: The default escape

character for ts_menu is Ctrl-X.

Hotkey to suspend the target session and display Power Management

Menu to control the power state of the target. Not available for Raw. Power Session Hot Key Default: Ctrl-P. NOTE: The default escape character for ts_menu is

Ctrl-X.

	For a Telnet/Raw session: TCP port to connect directly to a serial port.
TCP Port Alias	For SSH session: Alias of the port similar to ttySxx. Default: 70XX,
	where XX is the serial port number.
Port IPv4/IPv6 Alias	IPv4/IPv6 address used to connect directly to a serial port. Default: not
	configured (empty).
Port IPv4/IPv6 Alias	Interface (ETH0) associated with the IPv4/IPv6 alias.
Interface
Allow Session Only if	When the DCD is OFF, the appliance will deny access for this serial
DCD is On	port. Default: Disabled (allow access if DCD is OFF).
	When the input data matches one input string configured in Auto
Enable Auto Answer	Answer, the output string will be transmitted to the serial port. Default:
	Disabled.
	DTR Mode can be set to the following: Always On. Normal - the DTR
DTR Mode	status will depend on the existence of a CAS session. Off Interval -
	when the a CAS session is closed, the DTR will stay down during this
	interval. Default: Normal.