STORAGE SERVER USER ’S GUIDE
Reset Button (IP/Password)
To reset, press and hold until you hear 1 beep,
The password will be cleared, and its IP Address set to the default value of 192.168.0.2, with a Network Mask of 255.255.255.0
Uplink Button | When connected to a hub, this button should be UP. |
| If connecting directly to a PC or Macintosh via |
| Ethernet, depress this button. |
10/100BaseT connector
100BaseTX LED (amber)
10BaseT LED (green)
Printer Port
Use this to connect the Storage Server to your 10BaseT or 100BaseTX hub.
This will be ON if the LAN connector is using 100BaseTX.
This will be ON if the LAN connector is using 10BaseT.
Standard parallel printer port. A printer connected here becomes a "network printer."
LEDs
There are six status LEDs on the front panel:
Front Panel LEDs
Ready | Normally ON. |
| This blinks during Startup or Shutdown, and turns OFF after |
| the shutdown is completed. |
Alert | Normally OFF. |
(Red) | However, it will be On during the |
| the |
| there is a hardware error. |
| During a software upgrade, both the Ready and Alert LEDs |
| will blink. |
Disk Full | Normally OFF. |
(Amber) | Blinking indicates the Storage is 98% full. |
| ON indicates the Storage is completely full. |
Disk | Flashes during normal operation, when the Hard Disk is |
| accessed. |
LAN | Flashes during normal operation, when data is transmitted or |
| received via the LAN. |
|
|
4
