Setting Data Using an SD Card
An SD card (optional accessory) can be used as a setup card that stores up to eight files of settings menu specifications.
This data allows you to quickly reproduce an optimum state.
To format an SD card, write settings data or read data on an SD card, navigate the menu to the <SD CARD READ/ WRITE> screen from the FILE page.
An SD card may be inserted or removed, either before or after the power is turned on.
To insert an SD card:
Open the lid of the switch cover, and insert an SD card (optional accessory) into the SD card slot with the notch upward. Close the lid.
<Note>
An SD card must be inserted with the right side facing the slot. If the card is hard to insert, it may be reversed or upside down. Do not force it into the slot. Check the card before
To remove the SD card:
Open the lid of the switch cover, and ensure that the BUSY lamp is not illuminated. Then, further depress the SD card towards the main unit. This releases the SD card from the insertion slot. Take hold of the SD card and remove it. Close the lid.
SD cards must not be used or stored in an environment where they may be:
z Exposed to high temperatures/humidities; z Exposed to water droplets; or
z Electrically charged.
For storage, the SD card must be kept inserted into the AJ- SPX900E with the lid closed.
For an SD card formatted with a device that does not support SD standards, the message “FORMAT ERROR” appears at the upper right of the screen. In this case, reformat the card as follows. Note that the indication “FORMAT ERROR” does not disappear if the SD card is replaced with this menu page open. When the SD card is replaced, perform TITLE READ.
To format an SD card:
<Note>
SD cards may be formatted via the thumbnail screen. For more information, see
1 Navigate the menu to the <SD CARD READ/WRITE> screen.
2 Turn the JOG dial button to move the cursor to the menu option CARD CONFIG.
3 Press the JOG dial button to display the following message:
56