When using the Panasonic
1 Plug the
DC IN Socket
AC Adapter
z
2 Turn the AC adapter power ON.
3 Turn the
Adjusting its Position
Please refer to the viewfinder instruction manual.
Note: A slide rail is required to mount any viewfinder other than models
z If you need to buy a slide rail, please contact the store where you purchased the
Slide rail (VFC3995) Screws (XBS3+8VZ)
Mounting the Slide Rail
1 Undo the upper two screws for
remove the mounting unit.5 Leave the screws attached to the mounting unit.
Mounting unit
Screws
When using an external power supply other than the AC adapter
connected to the GND terminal, this could cause a fire or 2 Mount the slide rail, then tighten the two screws. personal injury.
Slide rail
4 | Pin No. | Signal | |
3 | 1 | GND | |
2 | 2, 3 | — | |
4 | +12V | ||
1 |
DC IN Socket
<Notes>
z When both the battery pack and AC adapter are connected, power is supplied from the AC adapter. The battery can be removed or mounted while using the AC adapter.
z When using the AC adapter, make sure you turn ON the AC adapter power before turning ON the camera- recorder’s power switch. If this sequence is reversed, the
z When connecting a battery to the DC IN socket, select the battery type listed under EXT DC IN SELECT. Select EXT DC IN SELECT from the <BATTERY/P2CARD> screen on the MAIN OPERATION page. In this case, however, the % display is disabled, even when using a digital battery.
67