9 | SECURE POST BRACKET TO GATE POST |
Mark holes for the post bracket. Remove the clamp and the operator, and set both aside. | |
Next, drill adequate holes in the gate post. |
Welder (Optional)
Secure the post bracket to the gate post using hardware. The gate operator (arm) must be level.
Flat Washers
Hex Nuts
Lock Washers
Carriage Bolts
10SECURE GATE BRACKET TO GATEDrill holes in gate (or reinforcement, if necessary) that are large enough for the gate bracket mounting hardware. Make sure the gate operator (arm) is level, and then secure the gate operator to the gate using hardware (not provided).
Welder
(optional)
NOTE: Some installations may require additional reinforcement be installed on the gate.
Angle Iron
Arm
Reinforcement
Area
Hex Nut
OR
Wood
Lock Washer
FlatWasher
Gate Bracket
Hex Bolt
Manually move the gate to verify that it opens and closes fully.
OR
Flat Bar
17 | Installation |