4.6 Climate control

The two-in-one weather cover

All models are equipped with the Chariot two-in-one weather cover, which consists of a plastic window that can be rolled up with mesh beneath it.

Opening the two-in-one weather cover:

First undo the outer tabs of the assembly at both velcro fasteners. Then lift the two-in-one weather cover upwards, pulling equally on both of its tabs.

TIP

The mesh provides limited UV protection.

The two-in-one weather cover is secured at the bottom by a double velcro fastener. First the velcro tag of the two-in-one weather cover is pressed onto the velcro surface on the carrier. Then the velcro on the carrier is pressed from the outside against the velcro tab of the two-in-one weather cover.

TIP

On the Cougar and CX, make sure the upper corners rubber seal of the two-in-one weather cover is properly seated. If this is not the case, the seal will not effectively prevent water penetration.

Sunscreen

A sunscreen is located under the upper rear of the two-in-one weather cover.

If it is not being used, it can be rolled up and secured with the loops located at the top corners. The two-in-one weather cover is then placed over it and fastened.

WARNING

Always make sure that the velcro fastener is properly fas- tened.

Sunscreen on the CX

On the CX the front extended length tinted fl ap can be rolled up and secured with two loops.

13

Page 13
Image 13
Chariot Carriers CX 2, CX 1 Climate control, Two-in-one weather cover, Opening the two-in-one weather cover, Sunscreen