Safety instructions for using the brake system on the CX 1 and CX 2 models:
•Before using the brake system for the fi rst time, acquaint yourself with its braking effect.
•On your fi rst journeys always take the Owner’s Manual with you in case adjustments need to be made to the brake system.
•Check the braking effect before each journey.
•Before each journey check that both brakes operate with the same force.
•Before each journey check that the lock nuts are tight on the adjusting screws.
•Before each journey check that there are no kinks in or other damage to the brake cables.
•Always ensure that when the parking brake is applied the spring button is fully pressed in. If this is not done, the brake lever could be released and the parked carrier could roll away.
•Only park the carrier on fl at surfaces.
•Check that the parking brake is working properly. Always check that the carrier cannot roll away. If the carrier is given a push, it should immediately come to a stop once it has been released.
•If the carrier is not held securely by the parking brake, the brake must be readjusted.
•Remember that the brake drums heat up when used, so there is a risk of burning yourself if you touch them.
•Before each journey make sure that the brake system adjusting screws are secured and not unscrewed too far.
•If you need to replace brake system components due to wear or for other reasons, only have replacement carried out by a Authorized Chariot Retailer.
•Keep the insides of the drum brake dry and free of dirt.
Performance characteristics
Inline skating with the Stroller is not permitted.
Assembly
To attach the stroller wheel, press the plastic button on the side of the VersaWing 2.0 until it can go no further. Then, from below, insert the upward pointing caster shaft of the stroller wheel into the vertical hole of the VersaWing 2.0 until it can go no further.
Release the plastic button. This now clicks back towards the outside, resulting in locking of the attachment axle of the stroller wheel.
DANGER
Always make sure that the stroller wheels are properly and fully engaged and locked. To check this pull the stroller wheels up and down in a vertical direction. Make sure that the plastic locking button has fully clicked back. Incorrect assembly may lead to accidents.
39
