Pressing down the locking button on the axle, insert the XC Skiing Kit into the axle socket on the Chariot CX until it can go no further. Release the locking button. The axle will now click if installed fully.
Make sure the skis are inserted correctly with the ski tips towards the front of the carrier.
Now secure the arms by inserting the security pin from above through the vertical hole in the arm and VersaWing 2.0 until it stops. Lock the security pin by looping the spring clip over the pins end that protrudes underneath the VersaWing 2.0.
DANGER
Always check that both ski frames are properly attached by pulling the ski frame outwards hard without pressing the axle’s locking button. To do this, lift the carrier slightly and hold it fi rm with one hand. Make sure that the ski cannot be pulled off, by giving it a few good shakes.
DANGER
Always make sure that the security pins of the ski arms are properly inserted to prevent the carrier from accidentally sliding away. You run the risk of an accident!
Fitting the ski arms to the carrier
Identical for all models.
Insert each arm into the VersaWing 2.0 until the vertical holes in the arms and VersaWing 2.0 are aligned with each other. The arms should now, at the back in the slot of the VersaWing 2.0, protrude about 2 cm / 3/4“ over the plastic edge.
TIP
The holes in the ski arms are larger than the security pins, so that the arms can rotate slightly around their longitudinal axes (in order to adapt to narrow or wide hips, and single and double width carriers).
45
