6
40. Solder (3) the connection (2) together using rosin core sol-
der (1).
41. Center the heat shrink tubing (2) over the solder joint and
heat using a heat gun. Heat the joint until the tubing is
tightly sealed and sealant (1) comes out of both ends of
the tubing.
42. Install the quarter trim panel (1) to the inside of the ve-
hicle, carefullyalign and install the bottom of the quar-
ter trim panel slots into the load floor first. Continue
to seat the remaining clips onthe panel, working from
the bottom up. Use hand pressure to seat the clips
(3).
43. Install the cargo tie downs and tighten the screw.
44. Install the load floor into its locked position.
45. Install the rear door scuff plate.
46. Install the C-pillar trim.
Aug 08, 2008 K6860631 Rev. 1