4
23. Look inside and note position of the retaining bosses.
24. Using special tool 9857 Power Outlet Remover (4), in-
sert the tool forcing bosses (1) out of base.
25. Pull out the base (3) through mounting ring by gently
rocking pliers.
26. Disconnect the electrical connector.
27. Mount the router as shown w ith the provided materials.
28. Connect the Wi-Fi power harness to the router.
29. Route the antenna cable along the left side of the vehicle,
across the lower instrument panel brace and over to the
shifter housing at the cigarette lighterconnector, securing
along the way and cut to the proper length.
30. Locate the cigarette lighter outlet wiring harness.
31. Cut each wire and remove 13 mm (0.5 in.) of insula-
tion from each wire that needs to be soldered/spliced.
32. Place a piece of supplied adhesive lined heat shrink
tubing on one side of each cut wire. Insure the tubing
will be long enough to cover and seal the entire sol-
dered area.
CAUTION: Do not use acid core solder.
33. Solder the supplied fused pigtail to Wi-Fi power har-
ness power wire.
Aug 08, 2008 K6860631 Rev. 1