7
33. Using a trim stick C-4755 or equivalent, disengage the
retaining tabs of the sill trim panel (1) from the retainer
clips inthe rear door sill (2) and remove the trim panel.
34. Install and secure the wi-firouter to the floor.
35. Route the wi-fipower harness from the router along
the sill securing where necessary. and cut to the
proper length.
36. Locate the cigarette lighter outlet wiring harness.
37. Cut each wire and remove 13 mm (0.5 in.) of insula-
tion from each wire that needs to be soldered/spliced.
38. Place a piece of supplied adhesive lined heat shrink
tubing on one side of each cut wire. Insure the tubing
will be long enough to cover and seal the entire sol-
dered area.
CAUTION: Do not use acid core solder.
39. Solder the supplied fused pigtail to Wi-Fi power har-
ness power wire.
Aug 08, 2008 K6860631Rev. 1