Chrysler K6860631

23. Remove the two screws (3).

24. Using a trim stick C-4755 or equivalent, separate the

four retaining clips (1) and remove the bezel (2).

25. Disconnect the electrical connectors and remove the

bezel.

26. Route and secure the Wi-Fi harness across the

steering column opening to the center stack and cut

to length.

27. Locate the cigarette lighter outlet wiring harness.

28. Cut each wire and remove 13 mm (0.5 in.) of insula-

tion from each wire that needs to be soldered/spliced.

29. Place a piece of supplied adhesive lined heat shrink

tubing on one side of each cut wire. Insure the tubing

will be long enough to cover and seal the entire sol-

dered area.

CAUTION: Do not use acid core solder.

30. Solder the supplied fused pigtail to Wi-Fi power har-

ness power wire.

Aug 08, 2008 K6860631 Rev. 1