4
23. Remove the screws and the cargo tie downs.
24. Remove the q uarter trim panel (1), by carefully pulling
at the clip locations (3).
NOTE: The load floor on Jeep Liberty must be removed inorder to route the Wi-Fi router harness. Repeatsteps
11 through 24 on the drivers side to remove the load floor assembly.
25. Remove the lift gate opening scuff plate.
26. Liberty only, remove the nuts (2) and lift the rear of
the floor panel (1) upand rearward to release from the
body hooks (4).
27. Access the storage compartment.
28. Drill a 13mm. (0.5 in.) holein the drivers side front
lower corner of the storage compartment, forward to-
ward the instrument panel.
29. Route the Wi-Fi electrical harness through the hole
and connect to the router.
30. Squarely position the router near the hole and secure
in place with the materials provided.
31. Route and secure the Wi-Fi power harness (2) from
the rear quarter panel, along the passenger side and
underneath the door sill scuff plate.
32. Route and secure the Wi-Fi power harness under the
glove box opening and behind the center stack and
cut the harness to the proper length.
Aug 08, 2008 K6860631 Rev. 1