5
WITHOUT FULL CENTER CONSOLE
21. Using a trim stick C-4755 or equivalent, disengage the
retaining tabs and remove the lower bezel panel (1).
22. Remove the two lower screws securing the cup holder
to the IP.
23. Fold the cup holder down and lower the cup holder (2)
close out panel by depressing the tab at the top of the
panel.
24. Remove the two screws from behind the close out and
remove the cup holder.
25. Using trim stick C-4755 or equivalent, disengage the
power outlet retaining tabs and disconnectthe power
outlet electrical connectors.
26. Remove the lower IP surround from the vehicle.
27. Route the Wi-Fi power harness behind the glove box
and up to the key on power outlet and cut to length.
ALL
28. Locate the cigarette lighter outlet wiring harness.
29. Cut each wire and remove 13mm (0.5 in.) ofinsulation
from each wire that needs to be soldered/spliced.
30. Place a piece of supplied adhesive lined heat shrink
tubing on one side of each cut wire. Insure the tubing
will be long enough to cover and seal the entire sol-
dered area.
CAUTION: Do not use acid core solder.
31. Solder the supplied fused pigtail to Wi-Fi power har-
ness power wire.
32. Place the strands of the power side wires overlapping each
other inside of the splice clip (1).
Aug 08, 2008 K6860631 Rev. 1