9
54. Install the 40% seat section (4) over the stud and seat
bracket and install the seat bracket bolts (6).
55. Tighten the seat bracket bolts (6) to 46 N·m (34 ft.
lbs.).
56. Install the nut (5).
57. Tighten the nuts (5 and 3) to 80 N·m (60 ft. lbs.).
58. Position the seat backs (3) up and latch.
59. Install the belt buckles (1) and install the bolt (2).
60. Tighten the buckle bolt to 66 N·m (49 ft. lbs.)
61. Install the bolts (4) and tighten t o 80 N·m (59 ft. lbs.)
62. Place the seat cushion into the vehicle and tuck the
rear of the cushion (1) up under the seat belt buckles
and rear seat back.
63. Lower the front of the cushion (3) down and install the
bolts (2).
64. Tighten the bolts to 80 N·m (60 ft. lbs.).
65. Locate trim clips and align metal clips to lift gate inner.
66. Tap on panel at each trim clip location (2) until properly
seated.
67. Install the left cargo net D-ring, if equipped.
68. Install the cargo floor.
69. Install the rear tonneau cover, if equipped.
70. Connect the battery negative cable.
71. Verify system operation.
Aug 08, 2008 K6860631 Rev. 1