Chrysler K6860631

24. Route the Wi-Fi power harness under the carpet to the

back of the storage bin through thek eyon power out-

let, slightly pulling back on the storage panel to gain

access.

25. Cut the Wi-Fi power harness to length.

26. Locate the cigarette lighter outlet wiring harness.

27. Cut each wire and remove 13 mm (0.5 in.) of insula-

tion from each wire that needs to be soldered/spliced.

28. Place a piece of supplied adhesive lined heat shrink

tubing on one side of each cut wire. Insure the tubing

will be long enough to cover and seal the entire sol-

dered area.

CAUTION: Do not use acid core solder.

29. Solder the supplied fused pigtail to Wi-Fi power har-

ness power wire.

30. Place the strands of the power side wires overlapping each

other inside of the splice clip (1).

Aug 08, 2008 K6860631 Rev. 1