1
WI-FI ROUTER
PT CRUISER
PROCEDURE STEPS:
NOTE: Using a test light, verify the cigarette lighteroutlet being used is ignition switched. Power must not be
present with the ignition in the OFF position.
1. Disconnect and isolate the battery negativecable.
2. Remove the four screws located inside the storage
bin.
3. Remove the two screws located under the cup holder
lining.
4. Disconnect the electrical connectors.
5. Remove the center console from the vehicle.
6. Mount the Wi-Fi router under the passenger seat with the providedmaterials.
7. Route and secure the Wi-Fi router harness under the seat track along center console harness and cut the Wi-Fi
power harness to the proper length.
8. Locate the cigarette lighter outlet wiringharness.
9. Cut each wire and remove 13 mm (0.5 in.) of insula-
tion from each wire that needs to be soldered/spliced.
10. Place a piece of supplied adhesive lined heat shrink
tubing on one side of each cut wire. Insure the tubing
will be long enough to cover and seal the entire sol-
dered area.
CAUTION: Do not use acid core solder.
11. Solder the supplied fused pigtail to Wi-Fi power har-
ness power wire.
Aug 08, 2008 K6860631 Rev. 1
INDEX
PRINT THIS VEHICLE