10-2
Catalyst2950 Desktop Switch Software Configuration Guide
78-11380-05
Chapter10 Configuring STP
Understanding Spanning-Tree Features
•Spanning Tree and Redundant Connectivity, page 10-8
•Accelerated Aging to Retain Connectivity, page 10-9
STP Overview
STP is a Layer 2 link management protocol that provides path redundancy while preventing loops in the
network. For a Layer 2 Ethernet network to function properly, only one active path can exist between
any two stations. Spanning-tree operation is transparent to end stations, which cannot detect whe ther
they are connected to a single LAN segment or a switched LAN of multiple segments.
When you create fault-tolerant internetworks, you must have a loop-free path be twee n a ll n ode s in a
network. The spanning-tree algorithm calculates the best loop-free pa th thr ough out a swit che d Laye r 2
network. Switches send and receive spanning-tree frames, called bridge protocol data units (BPDUs ), at
regular intervals. The switches do not forward these frames, but use the frames to construct a loop-free
path.
Multiple active paths among end stations cause loops in the network. If a loop exists in the net work, end
stations might receive duplicate messages. Switches might also learn end-station MAC addresses on
multiple Layer 2 interfaces. These conditions result in an unstable network.
Spanning tree defines a tree with a root switch and a loop-free path from the root to all switches in the
Layer 2 network. Spanning tree forces redundant data paths into a standby (blocked) state. If a network
segment in the spanning tree fails and a redundant path exists, the spanning-tree algorithm recalculates
the spanning-tree topology and activates the standby path.
When two interfaces on a switch are part of a loop, the spanning-tree port priority and path cost settings
determine which interface is put in the forwarding state and which is put in the bl ocking state. The port
priority value represents the location of an interface in the network topology and h ow well i t is loca te d
to pass traffic. The path cost value represents media speed.
Supported Spanning-Tree Instances
The switch supports the per-VLAN spanning tree (PVST) and a maximum of 64 spanning-tree instanc es.
For information about how spanning tree interoperates with the VLAN Trunking Protocol (VTP ), see the
“STP Configuration Guidelines” section on page 10-10.
Bridge Protocol Data Units
The stable, active spanning-tree topology of a switched network is determined by these elements:
•The unique bridge ID (switch priority and MAC address) associated with each VLAN on eac h switch
•The spanning-tree path cost to the root switch
•The port identifier (port priority and MAC address) associated with each Layer 2 interface
When the switches in a network are powered up, each functions as the root switch. Each switch sends a
configuration BPDU through all of its ports. The BPDUs communicate and compute the spanning-tree
topology. Each configuration BPDU contains this information:
•The unique bridge ID of the switch that the sending switch identifies as the root switch
•The spanning-tree path cost to the root
•The bridge ID of the sending switch