Cisco Systems AIRCAP3602IAK9 manual Connections for Cisco 3660 Routers

Chapter 3 Installing the Router

Connecting WAN, LAN, and Voice Cables

Connections for Cisco 3620, Cisco 3640, and Cisco 3631 Routers

Connect each WAN, LAN, and voice cable to the appropriate connector on the chassis or on a network module or interface card.

•Position the cables carefully, so that they do not put strain on the connectors.

•Organize cables in bundles such that cables do not intertwine.

•Inspect the cables to make sure that the routing and bend radiuses are satisfactory. Reposition cables, if necessary.

•Install cable ties in accordance with site requirements.

For cable pinouts, refer to the online document Cisco Modular Access Router Cable Specifications.

For more information about connecting and configuring network modules, WAN interface cards, and voice interface cards, refer to the following documents:

•Cisco Network Modules Hardware Installation Guide

•Cisco Interface Cards Hardware Installation Guide

Connections for Cisco 3660 Routers

Connecting WAN, LAN, and Voice Cables (Without Chassis Shield)

If your Cisco 3660 router does not use a chassis shield, perform this procedure:

Step 1 Connect each WAN, LAN, and voice cable to the appropriate connector on a network module or interface card.

Step 2 Route the cables to the left side of the router, and organize the cables in bundles. (See Figure 3-53.)

•Position the cables carefully, so that they do not put strain on the connectors.

•Organize cables in bundles such that cables do not intertwine.

Step 3 Inspect the cables to make sure that the routing and bend radiuses are satisfactory. Reposition cables, if necessary.

Step 4 Install cable ties in accordance with site requirements.

Cisco 3600 Series Routers Hardware Installation Guide

OL-2056-05 3-39