Cisco Systems ASR 1000 manual Configures the DBE to use a specific IPv4 H.248 control, For the SBE

Chapter 2 Configuring Integrated Session Border Controller

Configuring Integrated Session Border Controller DBE Deployment

	Command or Action		Purpose
Step 11	control-address h248 ipv4 {A.B.C.D}		Configures the DBE to use a specific IPv4 H.248 control
			address, which is the local IP address the DBE uses as its
	Example:		own address when connecting to the SBE.
	Router(config-sbc-dbe-vdbe)# control-address
	h248 ipv4 210.229.108.254
Step 12	controller h248 {controller-index}		Configures the H.248 controller for the DBE and enters into
			Controller H.248 configuration mode.
	Example:		In the example, the configured number 1 identifies the
	Router(config-sbc-dbe-vdbe)# controller h248 1		H.248 controller for the DBE.
Step 13	remote-address ipv4 {A.B.C.D}		Configures the IPv4 remote address of the H.248 controller
			for the SBE.
	Example:		In the example, 210.229.108.252 is configured as the
	Router(config-sbc-dbe-vdbe-h248)#		remote SBE IP address.
	remote-address ipv4 210.229.108.252
Step 14	remote-port {port-num}		Configures the port number of the H.248 controller that is
			used to connect to the SBE.
	Example:
	Router(config-sbc-dbe-vdbe-h248)# remote-port
	2947
Step 15	transport {udp tcp} [interim-auth-header]		Configures the DBE to use either UDP or TCP for H.248
			control signaling. The command also configures the H.248
	Example:		controller to insert the interim authentication header into
			the H.248 messages and set all fields in the header to zeroes.
	Router(config-sbc-dbe-vdbe-h248)# transport udp
	interim-auth-header
Step 16	exit		Exits Controller H.248 configuration mode.
	Example:
	Router(config-sbc-dbe-vdbe-h248)# exit
Step 17	attach-controllers		Attaches the DBE to an H.248 controller.
	Example:
	Router(config-sbc-dbe-vdbe)# attach-controllers
Step 18	exit		Exits VDBE configuration mode.
	Example:
	Router(config-sbc-dbe-vdbe)# exit
Step 19	location-id {location-id}		Configures a location ID for the DBE.
			The location ID is used by the network to route calls.
	Example:
	Router(config-sbc-dbe)# location-id 1
Step 20	media-address ipv4 {A.B.C.D}		Adds the IPv4 address to the set of addresses, which can be
			used by the DBE as a local media address. This address is
	Example:		the SBC virtual interface address.
	Router(config-sbc-dbe)# media-address ipv4		Configure this command for each IP address that you
	1.1.1.1 255.0.0.0		specified under the SBC virtual interface in Step 4.
		Cisco IOS XE Integrated Session Border Controller Configuration Guide for the Cisco ASR 1000 Series Aggregation Services Routers
2-4			OL-15421-01