Cisco Systems ASR 1000 manual What To Do Next, Examples, Troubleshooting Tips

Chapter 2 Configuring Integrated Session Border Controller

Configuring Integrated Session Border Controller DBE Deployment

	Command or Action	Purpose
Step 21
	activate	Initiates the DBE service of the SBC.
	Example:
	Router(config-sbc-dbe)# activate
Step 22
	end	Exits SBC-DBE configuration mode and returns to
		privileged EXEC mode.
	Example:
	Router(config-sbc-dbe)# end

What To Do Next

See the “Configuring H.248 Logging Level” section on page 2-6if you want to set console logging other than default logging and turn on H.248 logging messages.

See Chapter 4, “Configuring Media Address Pools” for information on what to configure next on the DBE.

Examples

The DBE does not always attach or detach from its controller immediately. You can use the show sbc dbe controllers command to display status information on whether the controller is attached or detached.

The following example uses the show sbc dbe controllers command to display status information showing that the vDBE with a location ID of 1 on an SBC called “mySbc” is attached to its controller:

Router# show sbc mySbc dbe controllers

SBC Service “mySbc” vDBE in DBE location 1

Media gateway controller in use: H.248 controller address

210.229.108.252:2944

Status:Attached

	Sent	Received	Failed	Retried
Requests	1	6	0	0
Replies	6	1	0	0
Configured	controllers:
H.248 controller 1:
Remote	address:	210.229.108.252:2944		(using default port)
Transport:		UDP

Troubleshooting Tips

Use this troubleshooting tip when you receive a “Bad getbuffer” log message.

Problem: You receive a “Bad getbuffer” log message

Cisco IOS XE Integrated Session Border Controller Configuration Guide for the Cisco ASR 1000 Series Aggregation Services Routers

OL-15421-01 2-5