Chapter 2 Preparing to Install the Router
Preparing to Connect to a Network
Token Ring Connections
The IEEE has established Token Ring as standard IEEE 802.5. Specifications indicate a maximum segment distance of 328 feet (100 meters) for UTP cabling.
Note To ensure agency compliance with FCC Class B electromagnetic emissions requirements (EMI), make sure that you use a shielded
Token Ring can operate at two different ring speeds: 4 and 16 Mbps. All devices on the Token Ring must use the same operating speed.
Use a Token Ring cable to connect the router to a switch. Refer to the section “Token Ring Port Pinouts” in the Cisco Modular Access Router Cable Specifications online document for the Token Ring port pinouts. This document is available online and on the Cisco Documentation
Serial Connections
Serial connections are provided by WAN interface cards and network modules. For more information on WAN interface cards, refer to the Cisco Interface Cards Installation Guide. For more information on network modules, refer to the Cisco Network Modules Hardware Installation Guide. These documents are accessible online and on the Cisco Documentation
Before you connect a device to a serial port, you need to know the following:
•Type of device, data terminal equipment (DTE) or data communications equipment (DCE), you are connecting to the synchronous serial interface
•Type of connector, male or female, required to connect to the device
•Signaling standard required by the device
Configuring Serial Connections
The serial ports on the asynchronous/synchronous serial network modules and the serial WAN interface card use
Serial DTE or DCE Devices
A device that communicates over a synchronous serial interface is either a DTE or DCE device. A DCE device provides a clock signal that paces the communications between the device and the router. A DTE device does not provide a clock signal. DTE devices usually connect to DCE devices. The documentation that accompanied the device should indicate whether it is a DTE or DCE device. (Some devices have a jumper to select either DTE or DCE mode.) Table
Cisco 3600 Series Routers Hardware Installation Guide
|
| ||
|
|
