Appendix B Using the ROM Monitor
ROM Monitor Command Descriptions
Modifying the Configuration Register in Menu Mode
Entering the confreg command without an argument displays the contents of the configuration register, and prompts you to alter the contents by describing the meaning of each bit.
The following display shows an example of menu mode:
rommon | 7> confreg |
|
|
| |
Configuration Summary |
|
|
| ||
enabled |
| are: |
|
|
|
break/abort has effect |
|
|
| ||
console |
| baud: 9600 |
|
|
|
boot: the ROM Monitor |
|
|
| ||
do you | wish to change the configuration? y/n | [n]: y | |||
enable |
| “diagnostic mode”? y/n | [n]: | y |
|
enable |
| “use net in IP bcast address”? y/n | [n]: | ||
enable |
| “load rom after netboot fails”? y/n | [n]: | ||
enable |
| “use all zero broadcast”? y/n | [n]: |
| |
disable |
| “break/abort has effect”? y/n | [n]: |
| |
enable |
| “ignore system config info”? y/n [n]: | |||
change | console baud rate? y/n | [n]: y |
|
| |
enter rate: 0 = 9600, 1 = 4800, 2 = 1200, | 3 = 2400 | ||||
|
| 4 = 19200, 5 = 38400, 6 = 57600, 7 = 115200 [0]: 0 | |||
change | the boot characteristics? y/n | [n]: | y | ||
enter to boot: |
|
|
| ||
0 = ROM Monitor |
|
|
| ||
1 = the boot helper image |
|
|
| ||
| boot system |
|
|
| |
[0]: | 0 |
|
|
| |
Configuration Summary enabled are: diagnostic mode
console baud: 9600
boot: the ROM Monitor
do you wish to change the configuration? y/n [n]:
You must reset or power cycle for new config to take effect
Modifying the Configuration Register by Hexidecimal Entry
Entering the confreg command plus a hexidecimal value changes the contents of the configuration register. The syntax is confreg [hexnum]; values entered are always interpreted as hexadecimal. The following example changes the value of the configuration register to the factory default:
rommon 7> confreg 0x2102
You must reset or power cycle the router for new configuration to take effect.
Cisco 3600 Series Routers Hardware Installation Guide
|
|
| |
|
|
