13-18
Cisco IE 2000 Switch Software Configuration Guide
OL-25866-01
Chapter 13 Configuring IEEE 802.1x Port-Based Authentication
Information About Configuring IEEE 802.1x Port-Based Authentication
802.1x Authentication with Downloadable ACLs and Redirect URLs
You can download ACLs and redirect URLs from a RADIUS server to the switch during 802.1x
authentication or MAC authentication bypass of the host. You can also download ACLs during web
authentication.
Note A downloadable ACL is also referred to as a dACL.
If more than one host is authenticated and the host is in single-host, MDA, or multiple-authentication
mode, the switch changes the source address of the ACL to the host IP address.
You can apply the ACLs and redirect URLs to all the devices connected to the 802.1x-enabled port.
If no ACLs are downloaded during 802.1x authentication, the switch applies the static default ACL on
the port to the host. On a voice VLAN port configured in multi-auth or MDA mode, the switch applies
the ACL only to the phone as part of the authorization pol icies.
Note The auth-default ACL does not appear in the running configuration.
The auth-default ACL is created when at least one host with an authorization policy is detected on the
port. The auth-default ACL is removed from the port when the last authenticated session ends. You can
configure the auth-default ACL by using the ip access-list extended auth-default-acl global
configuration command.
Note The auth-default ACL does not support Cisco Discovery Protocol (CDP) bypass in the single host mode.
You must configure a static ACL on the interface to support CDP bypass.
The 802.1x and MAB authentication methods support two aut hentication modes, open and closed. If
there is no static ACL on a port in closed authentication mode:
• An auth-default-ACL is created.
• The auth-default-ACL allows only DHCP traffic until policies are enforced.
• When the first host authenticates, the authorization policy is applied without IP address insertion.
• When a second host is detected, the policies for the first host are refreshed, and policies for the first
and subsequent sessions are enforced with IP address insertion.
If there is no static ACL on a port in open authentication mode:
• An auth-default-ACL-OPEN is created and allows all traffic.
• Policies are enforced with IP address insertion to prevent security breaches.
• Web authentication is subject to the auth-default-ACL-OPEN.
To control access for hosts with no authorization policy, you can configure a directive. The supported
values for the directive are open and default. When you configure the open directive, all traffic is
allowed. The default directive subjects traffic to the access provided by the port. You can configure the
directive either in the user profile on the AAA server or on the switch. To configure the directive on the
AAA server, use the authz-directive = open/default global command. To configure the directive on the
switch, use the epm access-control open global configuration command.
Note The default value of the directive is default.