Cisco Systems IE 2000 Configuration Examples for Performing Switch Setup Configuration

4-18
Cisco IE 2000 Switch Software Configuration Guide
OL-25866-01
Chapter 4 Performing Switch Setup Configuration
Configuration Examples for Performing Switch Setup Configuration
.
interface gigabitethernet1/1
no switchport
ip address 172.20.137.50 255.255.255.0
!
interface gigabitethernet1/2
mvr type source
<output truncated>
...!
interface VLAN1
ip address 172.20.137.50 255.255.255.0
no ip directed-broadcast
!
ip default-gateway 172.20.137.1 !
!
snmp-server community private RW
snmp-server community public RO
snmp-server community private@es0 RW
snmp-server community public@es0 RO
snmp-server chassis-id 0x12
!
end
To store the configuration or changes you have made to your startup configuration in flash memory, enter
this privileged EXEC command:
Switch# copy running-config startup-config
Destination filename [startup-config]?
Building configuration...
This command saves the configuration settings that you made. If you fail to do this, your configuration
will be lost the next time you reload the system. To display information stored in the NVRAM section
of flash memory, use the show startup-config or more startup-config privileged EXEC command.
For more information about alternative locations from which to c opy the configuration file, see
Appendix A, “Working with the Cisco IOS File System, Configuration Files, and Software Images.”
Configuration Examples for Performing Switch Setup
Configuration
Retrieving IP Information Using DHCP-Based Autoconfiguration: Example
Switch A reads its configuration file as follows:
• It obtains its IP address 10.0.0.21 from the DHCP server.
• If no configuration filename is given in the DHCP server reply, Switch A reads the network-confg
file from the base directory of the TFTP server.
• It adds the contents of the network-confg file to its host table.
• It reads its host table by indexing its IP address 10.0.0.21 to its hostname (switcha).
• It reads the configuration file that corresponds to its hostname; for example, it reads switch1-confg
from the TFTP server.