1-12
Cisco IE 2000 Switch Software Configuration Guide
OL-25866-01
Chapter 1 Configuration Overview
Default Settings After Initial Switch Configuration
If you do not configure the switch at all, the switch operates with these default settings:
• Default switch IP address, subnet mask, and default gateway is 0.0.0.0. For more information, see
Chapter 4, “Performing Switch Setup Configuration,” and Chapter 25, “Configuring DHCP.”
• Default domain name is not configured. For more information, see Chapter 4, “Performing Switch
Setup Configuration.”
• DHCP client is enabled, the DHCP server is enabled (only if the device acting as a DHCP server is
configured and is enabled), and the DHCP relay agent is enabled (only if the device is acting as a
DHCP relay agent is configured and is enabled). For more information, see Chapter 4, “Performing
Switch Setup Configuration,” and Chapter 25, “Configuring DHCP.”
• Switch cluster is disabled. For more information about switch clusters, see Chapter 6, “Configurin g
Switch Clusters,” and the Getting Started with Cisco Network Assistant, available on Cisco.com.
• No passwords are defined. For more information, see Chapter 7, “Performing Switch
Administration.”
• System name and prompt is Switch. For more information, see Chapter 7, “Performing Switch
Administration.”
• NTP is enabled. For more information, see Chapter 7, “Performing Switch Administration.”
• DNS is enabled. For more information, see Chapter 7, “Performing Switch Administration.”
• TACACS+ is disabled. For more information, see Chapter 12, “Configuring Switch-Based
Authentication.”
• RADIUS is disabled. For more information, see Chapter 12, “Configuring Switch-Based
Authentication.”
• The standard HTTP server and Secure Socket Layer (SSL) HTTPS server are both enabled. For more
information, see Chapter 12, “Configuring Switch-Based Authentication.”
• IEEE 802.1x is disabled. For more information, see Chapter 13, “Configuring IEEE 802.1x
Port-Based Authentication.”
• Port parameters
–
Operating mode is Layer 2 (switch port). For more information, se e Chapter 15, “Configuring
Interface Characteristics.”
–
Interface speed and duplex mode is autonegotiate. For more information, see Chapter 15,
“Configuring Interface Characteristics.”
–
Auto-MDIX is enabled. For more information, see Chapter 15, “Configuring Interface
Characteristics.”
–
Flow control is off. For more information, see Chapter 15, “Configuring Interface
Characteristics.”
• VLANs
–
Default VLAN is VLAN 1. For more information, see Chapter 17, “Configuring VLANs.”
–
VLAN trunking setting is dynamic auto (DTP). For more information, see Chapter 17,
“Configuring VLANs.”
–
Trunk encapsulation is negotiate. For more information, see Chapter 17, “Configuring VLANs.”
–
VTP mode is server. For more information, see Chapter 18, “Configuring VTP.”
–
VTP version is Version 1. For more information, see Chapter 18, “Configuring VTP.”
–
Voice VLAN is disabled. For more information, see Chapter 19, “Configuring Voice VLAN.”
• STP, PVST+ is enabled on VLAN 1. For more information, see Chapter 20, “Configuring STP.”