Cisco Systems IE 2000 Link Aggregation Control Protocol

40-6
Cisco IE 2000 Switch Software Configuration Guide
OL-25866-01
Chapter 40 Configuring EtherChannels
Information About Configuring EtherChannels
PAgP Interaction with Other Features
The Dynamic Trunking Protocol (DTP) and the Cisco Discovery Protocol (CDP) send and receive
packets over the physical ports in the EtherChannel. Trunk ports send and receive PAgP protocol data
units (PDUs) on the lowest numbered VLAN.
In Layer 2 EtherChannels, the first port in the channel tha t comes up provides its MAC address to the
EtherChannel. If this port is removed from the bundle, one of the remaining ports in the bundle pr ovides
its MAC address to the EtherChannel.
PAgP sends and receives PAgP PDUs only from ports that are up and have PAgP enabled for the auto or
desirable mode.
Link Aggregation Control Protocol
The LACP is defined in IEEE 802.3ad and enables Cisco switches to manage Ethernet channels between
switches that conform to the IEEE 802.3ad protocol. LACP facilitates the automatic creation of
EtherChannels by exchanging LACP packets between Ethernet ports.
By using LACP, the switch learns the identity of partners capable of supporting LACP and the
capabilities of each port. It then dynamically groups similarly configured ports into a single logical link
(channel or aggregate port). Similarly configured ports are grouped based on hardware, administrative,
and port parameter constraints. For example, LACP groups the ports with the same spee d, duplex mode,
native VLAN, VLAN range, and trunking status and type. After grouping the links into an EtherChannel,
LACP adds the group to the spanning tree as a single switch port.
LACP Modes
Table 40-2 shows the user-configurable EtherChannel LACP modes for the channel-group interface
configuration command.
Both the active and passive LACP modes enable ports to negotiate with partner ports to an
EtherChannel based on criteria such as port speed and, for Layer 2 EtherChannels, trunking st ate and
VLAN numbers.
Ports can form an EtherChannel when they are in different LACP modes as long as the modes are
compatible. For example:
• A port in the active mode can form an EtherChannel with another port that is in the active or passive
mode.
• A port in the passive mode cannot form an EtherChannel with another port that is also in the passive
mode because neither port starts LACP negotiation.
Tab l e 40-2 EtherChannel LACP Modes
Mode Description
active Places a port into an active negotiating state in which the port starts negotiations with other
ports by sending LACP packets.
passive Places a port into a passive negotiating state in which the port responds to LACP packets
that it receives, but does not start LACP packet negotiation. This setting minimizes the
transmission of LACP packets.