Cisco Systems IPS4520K9 Installing and Removing the Slide Rail Kit, 7-21, Package Contents, page

Chapter 7 Installing the IPS 4510 and IPS 4520

Installing and Removing the Slide Rail Kit

Figure 7-6shows all of the brackets that can be removed for the fixed rack mount.

Figure 7-6 Brackets for the Fixed Rack Mount

SFP1	SFP0														344202
	7
	6
	5	4
		3
		2			0
		1
		0
		1	MGMT	0
					1
					USB
					PWR	BOOT	ALARM	ACT
									VPN	PS1
SFP1	SFP0										PS0	HDD1	HDD0
	7												AUX	CONSOLE	RESET
	6
	5	4
		3
		2			0
		1
		0
		1	MGMT	0
					1
					USB
					PWR	BOOT	ALARM	ACT
									VPN	PS1	PS0	HDD1	HDD0
													AUX	CONSOLE	RESET

Step 4 Attach the slide rail kit hardware (front brackets and left and right side brackets) to the appliance. The brackets are labelled RIGHT and LEFT. This prepares the appliance for installation in the rack using the slide rail kit. Figure 7-7shows all of the brackets you need to install on the appliance.

Figure 7-7 Brackets for the Slide Rail Kit

333331

Installing and Removing the Slide Rail Kit

After you have installed the slide rail kit hardware, you can install the slide rail kit. This section describes how to install and remove the slide rail kit for the IPS 4510 and IPS 4520, and contains the following sections:

•Package Contents, page 7-22

•Installing the Chassis in the Rack, page 7-22

•Removing the Chassis from the Rack, page 7-28

Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.1

OL-24002-01 7-21