Manuals / Cisco Systems / Computer Equipment / Switch

Cisco Systems IPS4520K9, IPS4510K9 specifications 7-23, 9Square Studs for Square Hole Post

Models: IPS4510K9

1 36

Download 36 pages 45.7 Kb

Page 23

Figure 7-9 Square Studs for Square Hole Post

Chapter 7 Installing the IPS 4510 and IPS 4520

Installing and Removing the Slide Rail Kit

For square hole posts, square studs must be attached fully inside the square hole on the rack rail. For threaded hole posts, the round stud must fully enter inside the threaded hole rack rail (Figure 7-9).

Note After installing the square or round studs into the rack post, verify that the locking clip is fully seated and secure against the rack rail.

Figure 7-9 Square Studs for Square Hole Post

330561

		Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.1

	OL-24002-01			7-23
	OL-24002-01			7-23

Image 23

Cisco Systems IPS4520K9, IPS4510K9 specifications 7-23, 9Square Studs for Square Hole Post

Contents

C H A P T E R ContentsInstallation Notes and Caveats Installing the IPS 4510 and IPSProduct Overview Chassis Features Removal screws Description Indicatorthe back panel IndicatorDescription Figure 7-4 shows the back panel features IN OK IndicatorIndicator DescriptionIndicator SpecificationsDimensions and Weight Power7-10 AccessoriesEnvironment Model Memory ConfigurationsPower Supply Module Requirements Supported SFP/SFP+ Modules7-12 Installing the IPS 4510 and IPS1G SFP Module 10G SFP+ Modulea.Install the SFP/SFP+ module 7-13Step 5 Install the electrical cables 7-147-15 Removing and Installing the Core IPS SSPFor More Information Module 7-167-17 Removing and Installing the Power Supply ModulePower supply module and power supply module handle 7-187-19 Removing and Installing the Fan Module7-20 Installing the Slide Rail Kit HardwareInstalling the Chassis in the Rack, page Installing and Removing the Slide Rail Kit7-21 Package Contents, page7-22 Package ContentsInstalling the Chassis in the Rack Figure 7-9Square Studs for Square Hole Post 7-23Step 2 Secure the slide rail to the rack post with the provided #10-32screws by tightening the screws at the front and rear end of the slide rail to the rack post Figure 7-10.Both front and rear rack posts must be secured with the screws before you install the chassis 7-24Figure 7-11Installing the #10-32Cage Nuts 7-25Step 4 Install the chassis on the outer rail. Make sure that the U-barsare aligned to the outer rail evenly, then push the chassis into the rack Figure 7-26Figure 7-13Securing the Chassis to the Outer Rail 7-277-28 Removing the Chassis from the RackFigure 7-15Pressing Down the Release Hook 7-29Chapter 7 Installing the IPS 4510 and IPS Installing and Removing the Slide Rail KitPower off the sensor 7-30Bracket 7-31Step 12 Reattach the power cable to the sensor 7-327-33 Installing the Cable Management Brackets7-34 Troubleshooting Loose ConnectionsIPS 4500 Series Sensors and the SwitchApp IPS 4500 Series Sensors and the SwitchApp7-35 Chapter 7 Installing the IPS 4510 and IPSOL-24002-01 7-36Chapter 7 Installing the IPS 4510 and IPS IPS 4500 Series Sensors and the SwitchApp