Manuals / Cisco Systems / Computer Equipment / Switch

Cisco Systems IPS4520K9, IPS4510K9 specifications 7-27, 13Securing the Chassis to the Outer Rail

Models: IPS4510K9

1 36

Download 36 pages 45.7 Kb

Page 27

Figure 7-13 Securing the Chassis to the Outer Rail

Chapter 7 Installing the IPS 4510 and IPS 4520

Installing and Removing the Slide Rail Kit

Step 5 Tighten the screws to secure the chassis to the rack (Figure 7-13). Use the upper hole to secure the chassis to the rack.

a.For square hole racks, secure the chassis to the rack by installing the #10-32 screw into the cage nut that you installed in Step 3.

b.For threaded hole racks, secure the front of the chassis by installing the #10-32 screws into the rack threaded hole.

Figure 7-13 Securing the Chassis to the Outer Rail

330563

		Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.1

	OL-24002-01			7-27
	OL-24002-01			7-27

Image 27

Cisco Systems IPS4520K9, IPS4510K9 specifications 7-27, 13Securing the Chassis to the Outer Rail

Contents

C H A P T E R ContentsInstallation Notes and Caveats Installing the IPS 4510 and IPSProduct Overview Chassis Features Removal screws Description IndicatorIndicator Descriptionthe back panel Figure 7-4 shows the back panel features IN OK IndicatorIndicator DescriptionIndicator SpecificationsDimensions and Weight PowerAccessories Environment7-10 Model Memory ConfigurationsPower Supply Module Requirements Supported SFP/SFP+ Modules7-12 Installing the IPS 4510 and IPS1G SFP Module 10G SFP+ Modulea.Install the SFP/SFP+ module 7-13Step 5 Install the electrical cables 7-14Removing and Installing the Core IPS SSP For More Information7-15 Module 7-167-17 Removing and Installing the Power Supply ModulePower supply module and power supply module handle 7-187-19 Removing and Installing the Fan Module7-20 Installing the Slide Rail Kit HardwareInstalling the Chassis in the Rack, page Installing and Removing the Slide Rail Kit7-21 Package Contents, pagePackage Contents Installing the Chassis in the Rack7-22 Figure 7-9Square Studs for Square Hole Post 7-23Step 2 Secure the slide rail to the rack post with the provided #10-32screws by tightening the screws at the front and rear end of the slide rail to the rack post Figure 7-10.Both front and rear rack posts must be secured with the screws before you install the chassis 7-24Figure 7-11Installing the #10-32Cage Nuts 7-25Step 4 Install the chassis on the outer rail. Make sure that the U-barsare aligned to the outer rail evenly, then push the chassis into the rack Figure 7-26Figure 7-13Securing the Chassis to the Outer Rail 7-277-28 Removing the Chassis from the RackFigure 7-15Pressing Down the Release Hook 7-29Chapter 7 Installing the IPS 4510 and IPS Installing and Removing the Slide Rail KitPower off the sensor 7-30Bracket 7-31Step 12 Reattach the power cable to the sensor 7-327-33 Installing the Cable Management Brackets7-34 Troubleshooting Loose ConnectionsIPS 4500 Series Sensors and the SwitchApp IPS 4500 Series Sensors and the SwitchApp7-35 Chapter 7 Installing the IPS 4510 and IPSOL-24002-01 7-36Chapter 7 Installing the IPS 4510 and IPS IPS 4500 Series Sensors and the SwitchApp