Manuals / Cisco Systems / Computer Equipment / Switch

Cisco Systems IPS4520K9, IPS4510K9 specifications 7-25, 11Installing the #10-32Cage Nuts

Models: IPS4510K9

1 36

Download 36 pages 45.7 Kb

Page 25

Figure 7-11 Installing the #10-32 Cage Nuts

Chapter 7 Installing the IPS 4510 and IPS 4520

Installing and Removing the Slide Rail Kit

Step 3 For square hole racks, install one #10-32 cage nut on each side of the rack rail (Figure 7-11). Leave one square hole spacing above the slide rail. The cage nut will be used later to secure the chassis to the rack post. For threaded hole racks, no additional hardware is needed.

Figure 7-11 Installing the #10-32 Cage Nuts

332656

		Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.1

	OL-24002-01			7-25
	OL-24002-01			7-25

Image 25

Cisco Systems IPS4520K9, IPS4510K9 specifications 7-25, 11Installing the #10-32Cage Nuts

Contents

Installation Notes and Caveats ContentsInstalling the IPS 4510 and IPS C H A P T E RProduct Overview Chassis Features Removal screws Description IndicatorDescription Indicatorthe back panel Figure 7-4 shows the back panel features Indicator IndicatorDescription IN OKDimensions and Weight SpecificationsPower IndicatorEnvironment Accessories7-10 Power Supply Module Requirements Memory ConfigurationsSupported SFP/SFP+ Modules Model1G SFP Module Installing the IPS 4510 and IPS10G SFP+ Module 7-12a.Install the SFP/SFP+ module 7-13Step 5 Install the electrical cables 7-14For More Information Removing and Installing the Core IPS SSP7-15 Module 7-167-17 Removing and Installing the Power Supply ModulePower supply module and power supply module handle 7-187-19 Removing and Installing the Fan Module7-20 Installing the Slide Rail Kit Hardware7-21 Installing and Removing the Slide Rail KitPackage Contents, page Installing the Chassis in the Rack, pageInstalling the Chassis in the Rack Package Contents7-22 Figure 7-9Square Studs for Square Hole Post 7-23Step 2 Secure the slide rail to the rack post with the provided #10-32screws by tightening the screws at the front and rear end of the slide rail to the rack post Figure 7-10.Both front and rear rack posts must be secured with the screws before you install the chassis 7-24Figure 7-11Installing the #10-32Cage Nuts 7-25Step 4 Install the chassis on the outer rail. Make sure that the U-barsare aligned to the outer rail evenly, then push the chassis into the rack Figure 7-26Figure 7-13Securing the Chassis to the Outer Rail 7-277-28 Removing the Chassis from the RackChapter 7 Installing the IPS 4510 and IPS 7-29Installing and Removing the Slide Rail Kit Figure 7-15Pressing Down the Release HookPower off the sensor 7-30Bracket 7-31Step 12 Reattach the power cable to the sensor 7-327-33 Installing the Cable Management Brackets7-34 Troubleshooting Loose Connections7-35 IPS 4500 Series Sensors and the SwitchAppChapter 7 Installing the IPS 4510 and IPS IPS 4500 Series Sensors and the SwitchAppChapter 7 Installing the IPS 4510 and IPS 7-36IPS 4500 Series Sensors and the SwitchApp OL-24002-01